This is the projection distance Installing Your Projector in the Ceiling Measure the distance between the projector and where you want to position the screen. The light beam from the projector should be perpendicular to the screen for a rectangular or square imageĭistance Between The Projector And Screen.Move the projector as close to the center of the screen as possible.Your projector can be installed in four different configurations (see picture below): Close the lens cover when unit is not using Placing of Your Projector.Objects filled with liquids, such as vases, shall not be placed on the apparatus Remove & Close The Lens Cover.To reduce the risk of fire or electric shock, do not expose this apparatus to rain, moisture, dripping, or splashing.Caution and marking information is located at the rear or bottom of the apparatus.If the unit is displaying erratic behavior move away from any fluorescent lighting, as it may be the cause. Use of this unit near fluorescent lighting may cause interference regarding use of the remote.Changes or modified to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure.In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected from the mains socket outlet completely. Mains adapter is used as disconnect device and it should remain readily operable during intended use.Do not look directly into the projector light.When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus.Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Refer all servicing to qualified service personnel.Unplug this apparatus during lightning storms or when unused for long periods of time.Only use attachments/accessories specified by the manufacturer.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifier) that product heat. Install in accordance with the manufacturer’s instructions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |